DEL PowerVault 124T DLT VS160, Руководство пользователя

Страница: 34 / 79

Front Panel Administration: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/admin.html[12/5/2012 10:26:03 AM]
Back to Contents Page
Front Panel Administration: Dell™ PowerVault™ 124T DLT VS160
Autoloader User's Guide
Configuring the Autoloader SCSI Barcode Length
Setting the SCSI ID Setting Security
Setting Ethernet Setting Magazines
Setting the Time Setting Passwords
Barcode Reader
When you first power on the Dell PowerVault 124T DLT VS160 autoloader, it automatically runs a Power-On Self-Test (POST).
During the POST, the left (green) LED flashes. After the POST, the left (green) and right (amber) LED flash alternately back
and forth. Do one of the following:
If the autoloader powers on successfully, continue configuring the autoloader (see " Configuring the Autoloader ").
NOTE: The front panel requires a six-digit password to change the configuration (see " Setting Passwords "). The
LCD front panel default password for the Administrator is 000000 . The default password for the Operator is
111111 .
If the autoloader does not power on successfully, check the following:
Power switch is on.
Power cable is inserted correctly.
SCSI bus is terminated.
SCSI cable is connected to the autoloader and host computer.
No error code appears on the autoloader LCD.
If you cannot resolve the problem yourself, contact your service representative or go to support.dell.com .
When you first power on the autoloader, the setting for the Internet Protocol (IP) address is static with the address
192.168.20.128 . If you want to use Dynamic Host Configuration Protocol (DHCP) to change the IP address, see " Setting the
IP Address ." To determine the IP address when using DHCP, view the Ethernet status information (see " Setting the SCSI ID ").
Configuring the Autoloader
To configure the autoloader, start with the main menu on the front panel. If the main menu is not already visible on the LCD,
press Enter .
When you first power on the autoloader, the default is set with no password protection. However, after you set the security
option, all the configuration functionality is password-protected. You need an administrator-level password to configure the
autoloader.