12
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST
Snow Blower
Rev Jan 2016
Step 10: Skid Shoes
1. Skid shoes are stored in the hardware bag for
shipping.
2. Remove from hardware bag, and install skid shoes
using the provided fasteners
3. Insert the fasteners so the flat head of the carriage
bolt is toward the outside of the main housing.
CAUTION: Check the skids to ensure that the auger does
not contact the paved or gravel surface. Adjust skids as
necessary to make up for wear on the snow blower.
1. Check the tire pressure to ensure the tires are
properly inflated.
2. Move skid shoes up and down to the desired position
based on the surface texture.
If the surface is rougher adjust the skid shoes lower.
If the surfaces is smoother adjust the skid shoes
higher. Firmly tighten the nuts that secure both skids
Step 9: Drift Cutters (if desired)
1. The drift cutters are attached to the main hous-
ing in the stored position.
2. Remove the two bolts on each drift cutter.
3. Reattach the drift cutters in the operating posi-
tion.
4. Replace bolts and secure tightly.
Step 12: Filling Oil and Gasoline
1. Fill the engine with SAE 5W-30 engine oil. Fill the
engine with 1.2 to 1.5 quarts of oil. Fill up to the full
level mark on the dip stick.
2. Check that the fuel filter is clean and fill the tank with
unleaded gasoline.
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. Do not add fuel while the engine is
running or is hot. Keep open flames, sparks, and heat
away from the fuel and store fuel in containers
specifically designed for that purpose. ADD FUEL
OUTDOORS ONLY. IF THE FUEL IS SPILLED, DO NOT
START THE ENGINE. Manually push the snow blower
away from the spill and wipe up immediately.
DANGER
Step 11: Headlight
1. Attach the upper set of handlebars with the control
panel mounted.
2. Connect the headlight cable to the plastic connecter
that is coming from the snow blower.
Assembly Instructions
Need Help With Assembly?
1-919-550-3221 ext. 158
