36BB, 36BDB
BRUSH BEAST
18
Rev: Mar2011
BRUSH BEAST
Brush Mower
Lubrication Points
To ensure proper lubrication of moving parts, GXi recommends that you lubricate the following components with a high-
quality, EP2 high-temperature-based grease or equivalent. Should the conditions of operation be more severe than
normal, the lubrication interval may need to be shortened. GTR/OPE grease is the recommended lubricant.
Lubrication Point Locations
BRUSH BEAST mowers have four (4) lubrication points.
Note: The brush mower spindle bearings are both
sealed top and bottom to prevent contaminants from
entering the spindle. There is no service point on the
spindle.
Lubricate after every 50 hours of usage
Mower deck idler pulley
brackets (1 location)
2. Blade activation rod supports (2 locations: one at
the support under the fuel tank bracket and one
adjacent to the engine.)
3. Hydraulic
drive
system idler
puller support (1
location)
Note: Be sure the hydro unit is disengaged (see page 11)
before interchanging the optional attachment deck.
1. Remove the deck cover
by releasing the three
(3) T-handles.
2. Disconnect
the
clutch tension rod
connecting the deck
to the
chassis.
Deck Interchange
3. Remove the belt from
the engine pulley.
4. Using an 18 mm
wrench or socket,
remove the four (4)
deck retaining bolts.
5. Tilt handle bars forward and pull chassis from deck.
6. Reverse the steps to reconnect the optional
attachment deck. Refer to the owner manual
supplied with the optional deck for assembly and
operation instructions.
