13. Engine communication
13.1 Introduction to engine communication
Engine communication enables the SGC controller to communicate with different engine types over CAN bus. Some engine types
only allows the SGC to read information from the engine's ECU, while other types also makes it possible to regulate and transmit
different commands to the ECU.
Engine communication protocols are typically based on the SAE J1939 standard. It is a very comprehensive standard, and just a
small part is relevant for engine communication.
See the ECU user manuals for the ECU protocol technical description and details of each communication value.
Other engines and controllers
For engines and controllers not listed in this document, contact DEIF.
13.2 Default settings
The SGC controller is delivered with a set of default settings for engine communication. These settings are not necessarily correct
for the specific engine/generator set. Check all the settings before running the engine/generator set.
13.3 Supported engines
The SGC controller uses the J1939 protocol to communicate with these engines:
Manufacturer
SGC can write commands
Generic J1939
Yes
Cummins
Yes
Deutz - EMR
Yes
Iveco
Yes
MTU
Yes
Scania
Yes
Volvo Penta
Yes
13.4 Engine values on the display
You can configure the SGC controller to show values from the ECU on the display.
Figure 13.1
Display example
T.Coolant
NA
T.Fuel
NA
T.Oil
NA
Engine Temperature 1
ET1
USER MANUAL 4189341243A UK
Page 62 of 78
