Page 7
Main programmes
Anti-creasing
A 2-hour anti creasing programme to prevent laundry
from creasing will be activated if you do not take the
laundry out after the programme has come to an end.
This programme rotates the laundry in 60-second
intervals to prevent creasing.
Freshen up
10 minute programme without heat. Used for aerating
stuffy clothes that have been stored for some time.
Timer programmes
Select one of the 10 min...60 min...80 min... timer
programmes to achieve the final drying level. Dry the
cotton laundry at high temperatures and synthetic and
easy-care laundry at low temperatures depending on
the type of the laundry.
Press the “Low temperature” button for synthetics.
Auxiliary function
Low temperature
This function allows for drying at lower temperatures
and therefore saves energy. The warning LED will
light up when this function is selected. Use this
function for synthetic or delicate laundry.
Warning indicators
Warning indicators may differ according to the model
of your machine.
Using the dryer
5
Start
x
Sort the laundry according to fabric type.
x
Place the laundry in the drum.
x
Close the door.
Preparing the machine
1.
Plug in your machine.
2.
Open the door
3.
Place the laundry in the machine.
4.
Close the door
5.
Select the desired heat setting and drying time
using the timer knob. Refer to the drying guide in this
book.
6.
Press the “On/Off” button.
Pressing the “On/Off” button does not necessarily
mean that the programme has started. Press “Start/
Pause” button of the machine to start the programme.
Timer programme selection
Decide on the appropriate time using the drying time
table as a guide. Select the desired time with the
timer programme selection button.
are dried
to be ironed.
dried so that
they do not
before
placing
in the drawers.
dried so that
they do not
before
placing
in the drawers.
Drying time table guide
You may interrupt the cycle to add or
remove clothes at any time by simply
pushing the ON / OFF button and then
opening the door. The machine will re-
start when the door is closed and the ON/
OFF button is pushed once more.
At the end of the drying cycle there is a
cooling down period of about 10 minutes.
This cooling cycle effectively minimises
creasing.
At the end of the cycle the drum will stop
rotating.
Do not overload the machine. We
recommend loading the drum to the
halfway mark.
x
*
Permanent press garments should be removed
immediately after the drying cycle is completed
and put on a hanger to avoid creases. It is
recommended that half the normal load be placed
in the drum when drying these garments.
x
**The drying of woolen garments is not
recommended as shrinkage and distortion may
occur.
The following table is intended as a guide only.
Personal experience will soon tell what times are
required for typical loads.
Fabric
Size of load Time in mins
Cotton and Linen
Half
115-130
Synthetics and delicates Half
20-40
*Permanent press
Half
115-130
** Wool
Half
40-80
Drying guide
Quick Start Operations:
x
Switch the power on “A”
x
Select time duration on Knob “B”
x
Press Start to run
x
To Change time, press Start/Pause button
x
Select time duration on Knob “B”
x
Press Start to run