PAGE
6
OF 8
Fitting instructions for burner caps
Carefully align the 2 holes
in the aluminium burner
cap body with the ignition
electrode and the flame
failure sensor.
Gently lower the burner
cap into position
Centralise and level the
burner cap cover onto the
burner cap body.
BURNER BODY
BURNER CAP
IGNITION ELECTRODE
FLAME FAILURE SENSOR
STANDARD BURNER ASSEMBLY
WOK BURNER ASSEMBLY
JET CLEANING KIT
A
B
C
1
2
3
4
Gas Jet Cleaning Procedure
Every six months the gas jets on your hob should be cleaned to en-
sure continued efficient and safe operation.
This may be done using a Gas Jet Cleaning Kit which may be pur-
chased from your nearest Defy Service Centre.
The kit comprises of a sliding T-bar (A) a socket (B) and a
‘Classic pin’ (C).
Fit the T-bar to the socket and remove the pot stands, burner
caps and burner bodies.
1. Insert the socket into the central tube of the burner so that it locates
over the brass gas jet at the bottom of the tube.
2.
2. Gently loosen the brass gas jet by turning the socket in a anti-
clockwise direction.
3. Carefully lift the socket and loosened brass gas jet from the central
burner tube.
4. Insert the Classic pin into central hole of the jet and slide it up and
down until the jet is free of accumulated dirt.
