Page 10
Installation and connection
The product must be installed in accordance
with all local electrical regulations.
DANGER
Before starting any
work on the electrical installation,
disconnect the product from the
mains supply. There is the risk of
electric shock!
Power cable plug must be within
easy reach after installation (do
not route it above the hob).
DANGER
The product must be
connected to the mains supply
only by a qualified electrician.
The product's warranty period
starts only after correct
installation. The manufacturer
shall not be held responsible for
damages arising from
procedures carried out by
unauthorised persons.
DANGER
The power cable
must not be clamped, bent or
trapped or come into contact with
hot parts of the product.
A damaged power cable must be
replaced by a qualified
electrician. Otherwise, there is
risk of electric shock, short circuit
or fire .
Electrical connection
Connect the product to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician while using the
product with or without a transformer. Our
company shall not be liable for any damages
that will arise due to using the product
without a grounding installation in
accordance with the local regulations.
1 Minimum
of 50 mm
» Rear view (connection holes)
Final check
1. Connect the power cable and switch on
the hobs fuse.
2. Check the functions.
Connection must comply with national
regulations. The mains supply data must
correspond to the data specified on the type
label of the product. Type label is at the rear
housing of the product. The power cable of
your product must comply with the values in
"Technical specifications" table.
When installing the hob onto a
cabinet, a shelf must be installed
in order to separate the cabinet
from the hob as illustrated in the
figure. This is not required when
installing onto a built-in oven.
If it is possible to touch the
bottom of the hob once it has
been installed, then this exposed
area must be covered with a
wooden board.
Connection clamps are supplied
for hob installation. Do not make
connections to different holes, it
is unsafe and can damage the
electrical system.
Installing the product
1. Prepare the counter according to the
installation dimensions in the user manual.
2. In order to avoid foreign substances and
liquids penetrating between the hob and the
counter, please apply the putty supplied in
the package to the contour of the housing in
the counter before installation, make sure
that the putty does not overlap.
3. Place the hob onto the counter so that the
control buttons face forwards you.