5
4.3.1 Satellite
Configure the settings of satellites.
Satellites' list: Press Up/Down to select a satellite, whose settings will be
shown at right side.
LNB Type: Press LEFT/RIGHT/OK to show the list of LNB Types which is
shown as frequencies of local oscillator. You also can enter frequency by
User Single, User Dual at bottom of the list.
LNB Power:
Press LEFT/RIGHT to set the LNB power.
22K:
Press Left/Right to switch on or off the 22K,which is set with auto when
LNB Type is dual local oscillator.
Toneburst:
Enable or Disable the toneburst switcher.
DiSEqC1.0:
select the right port up to 4 for the right LNB.
DiSEqC1.1:
select the right port up to 16 for the right LNB.
Motor:
Press LEFT/RIGHT to select DiSEqC1.2 or DiSEqC1.3. Then Press
OK to show the menu to set position.
DiSEqC1.2:
Move the motor to a right position to lock the signal.
DiSEqC1.3:
Move the motor according to the local and satellite positions.
Move Auto:
Press LEFT/RIGHT to start to move West/East. It will be
stopped automatically when the signal is locked.
Move Continue:
Press LEFT/RIGHT to start to move West/East. It will
keep moving until you stop it.
Move Step[1]:
Press LEFT/RIGHT to move just a step.
Store Position:
store current position of motor.
Goto Position:
Press LEFT/RIGHT to goto the position stored.
Goto Reference:
Rest all the positions.
Goto X:
goto the position calculated from the local and satellite positions.
Add satellites:
Press Red to add a
new satellite, in which you must input
an unique longitude, and edit the
satellite's name with soft keyboard.
Edit satellites:
Press Green to edit the focused satellite.
Delete satellite:
Press Yellow to delete the focused satellite. Press OK to
confirm.
Single Satellite Scan:
Press Blue to pop the menu of scanning settings.
Scan Mode:
Press Left/Right to select default, which scan the default
transponders built in, Blind Scan and NetWork, which scan with NIT on.
Crytped: Press Left/Right to select All Channels or FTA Channels;
Service Type:
Press Left/Right to select ALL, DTV or Radio. Press OK to
start scanning with the above settings.
Multi-Satellites Scan:
Press OK to select satellites with the mark "V“, then
press blue to pop the menu of scanning setting. After Configuring like single
satellite scan, press OK to start multi-satellites scan.
