Defiance Safe 1 Hour Fire Safe Instruction Sheet
Defiance Safe Model ESD104-A-HL
Issue 5 1-08
Bolt Down Instructions
How to use Override Keys
How to Change Battery
1. Remove the bolt cap (unscrew anti-clockwise)
2. Locate the safe into the chosen position and open the door of the safe.
3. Mark the position of the hole (through the hole)
4. Slide the safe away from the mark and drill a 5/8” hole in the concrete floor with a
masonry drill to a minimum depth of 65mm.
5. After removing the dust from the hole, gently hammer the Loxin (supplied) into the hole
until it is flush with the floor
6.
Re-locate the safe into position and insert the bolt (supplied) through the hole in the safe
and tighten until firm
1. Slide battery cover to the left and remove
2. Remove batteries from housing.
3. With a Phillips screwdriver remove the two screws behind batteries
4. Lift plastic housing away (cheerfully not to damage wires)
5. Insert key into cylinder and turn 360
O
to unlock door.
6.
Reverse instructions to replace.
Note: Remember to turn key back 360
O
to return lock to standard operation.
1. When the battery is low the red lamp will glow after the ENTER button is pressed. Only a
few openings are now possible
2. The battery housing is located behind the square shaped panel
3. Slide the cover to the
LEFT
and lift forward
4. Change 4 x AA batteries. Note: Always use good quality
Alkaline
batteries. Other types
may cause problems
5.
Expected battery life of approx 1 to 2 year if used 5 times or less a day
