DeFelsko PosiTector RTR H, Инструкция по эксплуатации

Страница: 2 / 65

Introduction
The PosiTector
Replica Tape Reader
(
RTR H
) is a hand-held
electronic instrument that measures burnished Testex Press-O-
Film
TM
replica tape to produce peak-to-valley surface profile height
measurements. It consists of a PosiTector body (Standard or
Advanced) and probe.
To ensure best accuracy, the user will be prompted to
zero the probe every time the Gage is powered-up. It is therefore
recommended to clean the probe regularly with the included clean-
ing card. Cleaning is best performed when the Gage is powered
down.
NOTE:
1
Press the button to power up the Gage. To conserve battery
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode , the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
Quick Start
With the Gage powered down...
1. Clean the probe with the included cleaning card (pg. 5).
2. Power-up Gage by pressing the center navigation button .
3. Zero the probe (pg. 6).
4. Verify Gage accuracy (pg. 5).
5. Measure the burnished replica tape (pg. 3).
Menu Operation
To access the Menu, power-up the gage, then press the center
navigation button . Either the keypad or touch screen can be
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See Touch , pg. 9).
Select a menu option by touching it, or use the and but-
tons to highlight the desired option and press to select it.
On menus longer than one page, the current page number is dis-
played below the menu name. Navigate between pages using
when the first menu item is selected, or when the last