GB
31
Emergency disarming
If the Remote Control is broken or lost, disarm the
Alarm Module as follows:
A.
Consult your Card with the PIN Code and locate
your five-digit PIN Code.
B.
Follow the instructions on the Emergency Code Card.
Important:
If you make a mistake, you can repeat the
procedure from step 3 as often as required.
Keep your PIN Code Card always with you.
Do not leave it in the car!
Coding new DEFA Remote Controls
--- For more information, contact an authorised DEFA dealer
A. One short press on button B to turn off the alarm and immobilizer (if fitted). Emergency
disconnection can also be used.
B. Turn the ignition on and off 5 times in succession. The LED flashes rapidly when the
ignition is turned off the fifth time.
C. When you turn the ignition ON again, the LED should flash. Let the LED flash just as
many times as the first digit in your PIN code, and turn off the ignition (the LED stops
flashing).
D. Turn the ignition ON again and repeat the procedure until you have been through all of
the digits in the PIN code.
E. The LED flashes rapidly when the ignition is turned off after the correct PIN code has
been entered. If you make a mistake you can start from point C with the first digit in
your PIN code.
F. Turn the ignition on again, and press buttons A and B at the same time on the remote
control to be coded (one remote control at a time). Hold the buttons in until you have
received both light and sound receipt.
G. Turn off the ignition when all of the remote controls have been coded.
NB !
When you code the remote controls all of the old settings are deleted. You can code a maximum
of 4 controls.
The original remote control for your car does not have to be programmed. The Alarm Module will
automatically learn it.
DEFA CAN - G
S/N: 1234567
PIN-code: x-x-x-x
Your Emergency Code is:
1. Unlock and open the car door.
The Alarm is activated!
2. Turn the ignition ON and OFF five
time in a row. The Led “flickers”
3. When you turn ON the ignition once again, the LED
will blink. Let the Led blink as many times as the
first digit of your PIN-code, and turn OFF the ignition.
4. Turn ON the ignition and repeat the procedure (3)
until you have gone through every digit in your
PIN-code. The alarm is now disarmed. If you make
a mistake, start over again at step 3.
Immediately start the engine after the correct PIN code is entered.
