Dedrone
4 Set Up
IM-Inst-EK2536en
15
4.5
Set Up with LAN Connection
For this setup the Tec Case is not required. Instead of the Tec Case, you need a network access
for your DroneTracker and PC as well as the capability, to find out the IP address of the
DroneTracker in that network.
Requirements:
□
Plug socket for power supply
□
LAN access for your Sensors
□
Network access via Wi-Fi or LAN for your Laptop
Procedure:
Multi Sensor or RF-100 breaks
By overheating of the Tec Case, the Tec Case shuts down automatically and the sensor could
break.
•
Take care, that inside the Tec Case the temperature is not getting over 149 °F (65 °C), for
example by open the lid or providing shadow.
1
Turn on your notebook, set up the tripod, screw the tripod head on the tripod and
attach the Dedrone sensors to the tripods.
2
If you set up the RF-100, screw the antenna on
the screw threads at the top of the RF-100.
Therefor note the correct positioning of the
short and long antenna.
3
Turn on the main switch inside the Tec Case.
The battery display shows the charge state:
o
Green: Ready/standby
o
Orange
: low state of charge, full
functionality is not guaranteed,
charge
the battery
o
Red: Battery is empty, shut down in next
seconds.
4
Use the switch outside the Tec Case, to turn the power on.
Wait for
30 seconds
, before following the next steps.
The router boots and is going to provide the Wi-Fi network and is preparing LAN
communication.
short
long
