45
•
Select
the burner that you wish to use
by placing your finger squarely on the
corresponding control button
(fig. 1)
.
➡
The operating indicator for the bur-
ner lights up.
➡
The power indicators for this bur-
ner will begin flashing.
•
Choose
the heater power setting by
selecting and pressing the buttons for
the burner power setting
(fig. 2)
. The
power indicators stop flashing. Your hob
then automatically begins operating.
•
You can adjust
the power of the
burner by pressing on the
or
buttons.
This power setting is displayed on the po-
wer indication indicators.
➡
Pressing on
for position
7
(fig 3)
.
➡
Pressing on
for position
5
(fig. 4)
.
•
Locked :
press for approximately
three seconds on the
button. The
controls will be locked except for the
On/Off
command for the burners
and the main "Off" button for the whole
cooker. After three seconds, the "Lock"
indicator lights up.
•
Unlocked :
press for approximately
three seconds on the
(fig. 5)
.
The indicator goes out. All of the controls
can once again be used on the hob.
Using your hob in all simplicity
T
urning on the hob and adjusting the power setting
- In the event of accidental extinction (because of draughts for example), your cooker is
equipped with an automatic re-ignition system. This is limited to 2 successive re-ignitions.
- You can immediately turn off all burners by using the main "Off" button for the whole
cooker
.
- The flames on the burner are smaller near the grate supports to avoid any damage
being done to the enamel.
After intensive use, the cooking zone
may remain hot for several minutes.
The letter “
H”
H” is displayed during this
period. Do not touch the zones
concerned.
•
Residual heat indicator
Fig. 3
Fig. 4
Fig. 5
Fig. 2
Fig. 1
99643032_A_ML_FR-EN.qxp 21/08/2007 14:20 Page 45
