DeDietrich DTG1410X, Руководство по установке и использованию

Страница: 21 / 29

21
F
itting recommendations (cont'd)
The hob must be built into the worktop of a support cupboard.
This worktop must be at least 3 cm thick and heat-resistant or
else coated with a heat resistant material.
Please check that there is provision for ventilation at the
cabinet to ensure proper operation of the gas hob.
A side-clearance of at least 30cm should be left to the right and
left of the hob, 5.3cm from the rear wall.
And a side-clearance of at least 40cm should be left to the right
and left of the burner, 12cm from the rear wall.
A tall cupboard or partition too close to the hob would hinder
free movement of kitchen utensils.
If a horizontal partition is put under the hob, it must be placed
between 10 and 15 mm from the bottom of the work top. In
any case, do not keep any sprays or pressurized containers in
the compartment which could be just under the hob.
To ensure sealing between the cupboard and the worktop
follow points below:
1- Remove the pan support grates, the burner caps and heads
after checking their position.
2- Turn the hob over and place it gently over the opening in the
worktop paying attention not to damage the control knobs and
lighters.
3- Stick the foam seal around the outside of the hob.
4-Put the hob back the right way up and place the burners, caps
and pan grates back in position.