DeDietrich DPE7620XF, Руководство по установке и использованию

Страница: 33 / 40

9
INSTALLATION
• 1
1 Connection via a flexible metal
hose (stainless steel) with screw
connectors (in conformity with the local
regulations).
2 Connection with a flexible
reinforced rubber hose with
mechanical screw connectors (in
conformity with the local regulations).
When connecting the gas to your
hob, if you have to change the direction
of the elbow fitted into the appliance:
• Change the seal.
• Tighten the nut on the elbow ensuring
that you do not exceed a tightening
torque of 17 N.m.
• Gas supplied from a cylinder or tank
(butane/propane gas) (1.3.2) . For your
safety, you must choose only one of the
following three connections:
1
Connection via a rigid copper pipe
with mechanical screw connectors (½"
gas standard). Connect directly to the
elbow on the appliance.
2
Connection with a flexible metal
hose (stainless steel) with screw
connectors (in conformity with the local
regulations).
3
Connection with a reinforced
flexible rubber hose with mechanical
screw connectors (in conformity with
the local regulations)
In an existing installation, a flexible hose
fitted
C
with jubilee clips (in conformity
with the local regulations).
In this case an end connector must be
used with a sealing washer
A
fitted
between the end connector
B
and the
elbow on the hob.
You can purchase the end
connector and the sealing washer from
your after-sales department.
Tighten the end connector to a
torque not exceeding 25 N.m.
1•4 - CHANGING THE TYPE OF GAS:
Your appliance is supplied ready
for use with natural gas.
The injectors required for adapting
it to butane/propane can be found in
the plastic bag containing this guide.
Whenever you change the gas type, you
must follow these steps in turn:
1. Change the gas connection,
2. Change the injectors,
3. Adjust the retarder on the taps.
1) To change the gas connection :
- refer to the "Gas connection“
paragraph.
2) Change the injectors, proceeding as
follows :
- Remove all the supports, burner caps
and heads.
- Fully insert the starboard socket
L
wrench on the injector
U
.
(1.4.1)