DeDietrich DPE7620XF, Руководство по установке и использованию

Страница: 31 / 40

7
IDENTIFICATION
• 0
INSTALLATION
• 1
Identify your type of hob by comparing
the number and layout of the burners
on your appliance with the illustrations
(0.1.1) and (0.1.2) and (0.1.3) .
Make a note of the references of your
appliance on the "After-Sales Service
and Customer Relations" page so that
you can readily find them in future
(6.1.1). This page also explains where to
find them on your appliance.
1•1 - FITTING :
This worktop must be at least 3 cm thick
and heatresistant or else coated with a
heat resistant material.
Any possible wall unit over the cook-top
must be placed at a distance of at least
760 mm from the top.
It is advisable to isolate the appliance
from the piece of furniture below with a
separator, leaving a depression space of
at least 10 mm (1.1.2) .
If the hob is going to be installed on
the top of an oven, precautions must
be taken to guarantee an installation
in accordance with current accident
prevention standards..
Under no circumstances keep any
sprays or pressurised containers in any
compartment below the hob (see "Safety
guidelines“ chapter).
Follow the guidelines in the sketch.
(1.1.1).
• Remove the "pan supports", burner
caps and burner heads, noting their
original positions.
• Turn the hob upside down and place
it carefully over the top of the base
unit, so as not to damage the knobs or
igniters.
• To ensure a good seal between the
body of the hob and the worktop, stick
the foam seal
S
around the edge
of the body, before installing the hob
(1.1.3).
• Placez votre table de cuisson dans
l’ouverture du meuble support en
prenant soin de tirer la table vers soi.
• Place the hob over the opening in the
base unit, taking care to pull the hob
towards you.
• Fit the burner heads, caps and pan
supports .
• Connect your hob to the gas (see
"Gas connection" section) and to the
electricity (see "Electrical connection“
section).
• If you wish, you can secure the hob in
position, using the four fixing clam
C
and screws supplied supplied (1.1.4)
fixing them to the four corners of the
housing. It is essential that you use the
holes provided for the purpose, as per
the drawing.