e n g l i s h
cookware. The side grills are pyrolysis safe and may be
left inside the oven during pyrolysis.
CLEANING THE OUTER SURFACES
To clean both the electronic programmer window and the
oven door, use a window washing product applied to a soft
cloth. Do not use abrasive creams or scouring sponges.
CLEANING THE INNER SURFACES
NO PYROLYSIS OVENS
• Smooth side panel models (3.1.1).
- Clean the still-warm oven with a cloth dipped in hot, soapy
water.
• Rough side panel, self-greasing, catalytic models (3.2.1)
REPLACING ROUGH CATALYTIC SIDE PANELS
The oven has an enclosure fitted with removable panels
covered with a special microporous enamel (catalytic
enamel) which gives them self-degreasing properties. As
soon as dirt appears, it spreads out and is dispersed into the
microporous holes. It is oxidised on both sides and gradually
disappears. The self-degreasing enamel is mainly suited for
fatty, rather than sugary substances. This is why the oven
floor, which is more subject to sugary overflow, is not
covered with this enamel.
We strongly recommend :
- That you do not scrub these catalytic walls with metallic
brushes, pointed or sharp instruments.
- That you do not try to clean them with commercial
scouring products.
- When grilling food, the temperature of the walls is not
always sufficient to eliminate major spattering of fat.
In this case, when you have finished cooking, leave the oven
switched on for 20 to 30 minutes at the maximum
temperature for the sequence chosen.
If traces of spatter remain, they will be reduced during
subsequent cooking operations.
It is recommended that you replace the two catalytic side
panels when their self-degreasing capability is no longer
effective.
Start by removing the wire shelf side supports – see the
“Removing wire shelf supports” section).
Remove the two old catalytic side panels and replace them
with new ones (3.2.1).
Warning
For any cleaning operation inside the oven cavity, the
oven must be switched off.
Before starting to disassemble the appliance, allow it to
cool down and ensure that it has been disconnected
from the power supply.
REMOVING THE WIRE SHELF SUPPORTS
Wire shelf supports with hooks.
To remove them, lift up the front part of the shelf support to
disengage the front hook from its housing (3.3.1).
Then gently pull the whole of the support towards you and
lift the back to release the rear hook from its housing (3.3.2).
Pull out the two shelf side supports.
Wire shelf supports with clip system.
- Push down on the upper part of the shelf support to unclip
it from the central support (3.3.3). Tilt the support towards
the inside of the oven and lift gently upwards to disengage
it from the two holes at the bottom (3.3.4).
To re-fit the shelf supports after cleaning, follow the above
steps in the reverse order.
3.1
3.2
3.3
