DeCrane Aerospace Audio International
DVD-9101-201-x Installation & Operation Manual
Document # 540339, Rev A, 02/2008
Page 13 of 24
Activate monitors and speakers from the appropriate control panels. Audio
will be supplied through headphones and/or speakers per system design.
Make certain that the monitor(s) connected to the DVD Player are on and
functional.
Be certain to load the disc correctly—if the DVD has a sticker, it
should be loaded with the sticker facing up!
Gently push the into the
DVD slot. The DVD unit will accept the DVD and pull it inside.
The disc should begin loading, which will be indicated on the monitor
screen. If the disc does not start playing automatically after it has loaded,
then use the DVD Player’s front panel buttons or the handheld remote
control unit to select PLAY. DVD material should appear on the
appropriate monitor. This material is usually a menu, but this may vary,
depending on individual DVD configuration. For CDs, the tracks should be
listed on the side of the screen. Audio should channel through the
speaker/headphone system.
If sound cannot be immediately heard through speakers or headphones, it
may be that the volume is too low and should be increased appropriately.
Note that there are no audio controls on the DVD-9101-201-x. Any
desired adjustments must be performed through other audio distribution
devices.
If power is interrupted (>200 msec) or power drops below +18 VDC while
a disc is playing, the player may shut down. If a DVD disc is in the player,
the unit will begin playback from the beginning of the disc automatically.
Insert
Disc
Here