Decatur Electronics Surface Velocity Radar SVR2-01, Руководство пользователя

Страница: 26 / 48

SV
R
2-
01
™
U
se
r’s
M
an
ua
l
26
SVR™ focuses its data processing . Towards the end of the first 10
seconds, the displayed velocity will be accurate . (Do not pull the
trigger again or the measurement cycle will be terminated .)
• After 10 seconds the dash ( - ) is replaced by the number "0"
(zero) indicating that the next measurement cycle has started .
The speed shown is the average velocity over the last 10 seconds
and will remain in the display until the current measurement
cycle is completed . The leading “0” will continue flashing .
• After 5 seconds the measurement cycle is completed and the
"0" (zero) is replace with the number "1" indicating that the next
measurement cycle has started . The speed shown in the display
is the average velocity over the last 15 seconds and will remain
unchanged until this cycle is completed . The number “1” will
continue flashing .
• After 20 seconds, the number in the left hand side of the
display updates to "2" and runs the same speed measurement
as described previously . The SVR™ will continue to take speed
measurements every 5 seconds and display the new average
speed and update the number shown on the left hand side of
the display until all measurement cycles have been completed .
• After 60 seconds have passed, the SVR™ will have completed
ten separate 5-second batches of velocity measurements . The
display will indicate the average of these measurements .
• Press the MODE button if you want to change the display
resolution . The speed can be displayed in either 10ths or 100ths .
If the user pulls the trigger once the speed measurement cycles have
finished, the reading will be canceled and SVR™ is now ready to take
a new measurement .