
Sp
eedSp
y™
U
ser
’s & I
nstalla
tion M
anual
12
tapped with the narrow side facing about 3 inches directly in
front of the antenna . (See Figure 3 .7) .
Figure 3.7
Place the vibrating tuning fork about 3 inches in front of the antenna
• Only tap the tuning fork against hard plastic, wood, and
materials that are softer than metal . Repeatedly tapping
the tines on hard surfaces, such as metal and concrete,
can damage the tines and invalidate the fork for future
tests .
2 . Observing the LED on the EZ Stat™, pull the tuning fork to one
side so that the fork is no long able to be read by the antenna .
The LED on the EZ Stat™ will blink red once indicating that the
information has been saved .
If the LED does not blink red once, then there may be an issue with
the EZ Stat™ . Remove the EZ Stat™ and plug it into the computer
that has the EZ Stat™ software installed on it . Open the software and
press the "Connect" button . Check to make sure that the box labeled
"Product" says "OnSite Series Trailers" . If the box says "Decatur Radar"
then change the setting to "OnSite Series Trailers" and press the
"Disconnect" button and try the EZ Stat™ again in the SpeedSpy™ .