G
en
es
is I
I S
ele
ct D
ire
cti
on
al
™
U
se
r’s
&
In
sta
lla
tio
n M
an
ua
l
G
en
es
is I
I S
ele
ct D
ire
cti
on
al
™
U
se
r’s
&
In
sta
lla
tio
n M
an
ua
l
20
25/Aug/2010
21
25/Aug/2010
3. Hand-Held Remote Controls
REAR ANTENNA
TARGET LOCK
(STOPWATCH START/STOP)
FASTER TARGET
SELF-DIAGNOSTIC
POWER
REAR ANTENNA
MODE
VOLUME
RANGE CONTROL
(STOPWATCH DISTANCE)
SQUELCH
OPTION
(STOPWATCH MODE)
SPEAKER
Figure 3a
The S778-41CC-0 hand-held remote control unit .
Figure 3b
The S778-41CC-0 hand-held remote control
unit with detachable cable .
• If the hand-held remote is removed during operation,
RMT? appears in the Mode window and will stay on
until the remote is plugged back in .
3.1 Control Buttons
POWER (PWR): Powers the Genesis II Select Directional on and off .
OPTION (OPTN): The City/Highway option helps reduce shadowing
by setting a different minimum patrol speed for city and highway
speed conditions . This option works only while the unit is set in a
Moving Mode and the motor vehicle is not equipped with a VIP .
STOPWATCH MODE [OPT]: To place the Genesis II Select Directional
into the Stopwatch operational mode, press and hold the OPTN
button for two seconds . The letters StpW will appear in the MODE
window . Press the OPTN button again to exit this mode . See section
5 .9 for a full description of the Stopwatch Mode .
PATROL SPEED LOCK, RECALL and BLANKING: This feature comes
standard with the Genesis II Select Directional and will enable the
patrol officer to lock a target speed which will then become displayed
in the locked window, while remembering internally what the patrol
speed was at the time the speed was locked . The Genesis II Select
Directional will, as long as the antenna remains activated, continue
to track both the speed of the target in the target window and the
patrol motor vehicle speed in the patrol window .
1 . To blank the patrol speed, press the OPTN button . Then press the
OPTN button again to recall it .
2 . To permanently remove the locked patrol speed, reactivate the
antenna by turning it on .
TEST (TEST): Pressing the TEST button starts an extensive self test
of the radar unit’s circuitry . If the self test fails, the SYS message will
appear in the MODE window .
Pressing and holding the test button activates the menu feature . This
feature allows the operator to adjust some of the options of the radar
which are officer preferences . See Appendix B for more information .
