Dean Forge Croft Clearburn Junior, Руководство по эксплуатации

Страница: 7 / 18

7
Chimney
All croft clearburn stoves must have a minimum chimney height of 4m measuring from the
stove outlet, the chimney must not be less than 150mm (6”) internal diameter.
These stoves are not suitable to be used in a flue-shared situation.
The chimney must be sound and of not too large a section. If not sound or too large, a liner
will have to be fitted; s/s or ceramic suitable for solid fuel.
If the chimney draw is too high a flue stabilizer will have to be installed. When the chimney is
warm the draw should not be lower than 0.10 water gauge.
All appliances have been tested at 12 PA with the doors closed.
If the flue is connected directly into a existing chimney without a liner the register plate must
be fitted with removable doors to facilitate cleaning.
If its not possible to fit doors in the register plate then a cleaning door will need to be fitted as
near as possible to the connecting length of flue in the front, side or back of the chimney
breast.
Hearth, Surround and Register Plate
The stove must stand on non-flammable material at least 12mm thick (1/2”). The hearth must
extend at least 225mm in front of the firebox and 150mm to the sides.
If the stove is in a fire opening made of non-combustible materials, we recommend a 150mm
gap to the sides and 300mm above from non-combustible materials.
The appliance must be installed on a floor with an adequate low bearing capacity.
If the construction doesn’t meet the existing prerequisite the floor must be reinforced and a
load distributing plate could be fitted.