Dea SWINGER, Руководство по эксплуатации

Страница: 7 / 19

21
6 STANDARD PROGRAMMING
1 Power Supply
Give power supply, the display shows the following symbols “ ”, “ ”, “ ” and then “- - - -”.
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START command
is given, the position reset procedure is performed (see “rESP” in the table “WORKING STATUS MESSAGES” on page 26.
2 Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it’s correct);
Total operations counter (* see P064):
i.g.: = 3x1000* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.: = 5*x500 = 2500 operations remaining be-
fore the maintenance intervention request ( = ma-
noeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or rele-
ase the button to exit the parameter.
3 Selection type of operators
! IMPORTANT !
1. Scroll down the parameters with and keys until you visua-
lise P028;
2. Access the parameter by pressing the key;
3. Verify that the value corresponds to d000 (GEKO), otherwise, you
must select it by pressing and keys;
4. Confirm your choice by pressing the key (display returns again
to P028).
4 Selection operating with or without encoder
! IMPORTANT !
Warning: Remember to correctly set the jumpers J5 and J9.
1. Scroll down the parameters with and keys until you visua-
lise P029;
2. Access the parameter by pressing the key;
3. Acting on and keys, set:
- d000=for operators with encoder;
- d001=for operators without encoder;
4. Confirm your choice by pressing the key (display returns again
to P029).