Dea ADVANCE, Инструкции по эксплуатации и предупреждения

Страница: 28 / 164

26
8 ADVANCED PROGRAMMING
Belo w fi nd the description of some programming procedures relative to the management of the radio-commands memory and advan-
ced confi guration of the command inputs.
To access the control unit advanced programming functions, remove the Jumper J4 from the board . Use the and keys to go to
P005 and hold the key down for 5 seconds (at this point, all of the parameters are visible and can be modifi ed).
1 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the and keys until the screen reads
P013;
2. Access the parameter by pressing the button;
3. The “Input Status” is shown on the screen (check that this is correct):
4. Press the button again;
5. The “Total Operation Counter” is shown on the screen
(* see P064):
Ex: = 3x1000* = 3000 operations executed
6. Press the button again;
7. The “Maintenance Operation Counter” is shown on the screen (* see
P065):
Ex: = 5*x500 = 2500 operations still to be carried out before
the maintenance intervention request ( = maintenance operation
counter disabled)
8. Press the button again to exit the parameters (P013 is shown on the
screen again).
2 Transmitters coding selection
1. Scroll down the parameters with and keys until you visualise
P027;
2. Confi rm by pressing on the key;
3. Select the type of transmitter by scrolling and keys:
- d000=fi x rolling-code ( suggested );
- d001=complete rolling-code;
- d002=dip-switch;
4. Confi rm by pressing on the key (display shows again P027).
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004)
AFTER you have set the new encoding.
3 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Confi rm by pressing on the key;
3. By pressing on and , set up the desired value;
4. Confi rm by pressing on the key (display shows the parameters
previously selected).
For the complete list of the “Operating Parameters” See the
table on page. 33.