2
USER INSTRUCTIONS
Read these instructions before using the appliance.
When lighting for the first time, burn outdoors for 4 hours minimum to cure the synthetic coals.
(The coals give off an odour when curing.)
The appliance must be installed and used in accordance with the regulations, which are currently in force.
The heater should be positioned on a level surface. Only use in a well ventilated area.
The minimum room size when using this appliance is 64 cubic metres with a minimum ventilation of 80 cm squared area.
To fit a Butane Gas Regulator:
Attach regulator to end of hose and secure with hose clip.
Note
: for ease of fitting hose, lubricate ribbed nipple of regulator with a soap solution.
To fit a Butane Gas Cylinder:
(Ensure that the area is free from any unprotected combustible material or substance
1. The changing and connection of LPG cylinders must be undertaken in a flame free atmosphere
2. Attach the regulator to the new cylinder. Ensure that the hose is not twisted or damaged in any way.
3. Use gas cylinders with a gas capacity of 7-15kgs.
4. In order to remove the regulator you must ensure that the regulator is in the “off” position.
Before lighting:
1. Inspect the hose assembly. If the hose is cut or shows signs of excessive wear, or is leaking it must be replaced prior to
operation of the heater
2. Ensure the heater is positioned with a minimum clearance above and beside of 0.6metres from flammable materials
both vertically and horizontally.
3. Ensure that the glass panel is closed securely.
To Light Heater:
1. Fit battery type AA provided into ignition button. See Fig.1
2. Turn on heater at gas cylinder regulator
3. Turn the control knob to the position and hold down for 5 seconds to ensure all air in the
hose is expelled.
4. Push control dial down and turn to flame position and at the same time press the sparker
button to light the pilot. If there is no spark check the battery type AA is correctly fitted. (the
pilot flame can be viewed at the right hand side of the coal bed)
5. If pilot does not light turn control dial to off position. Wait one minute and repeat step 3.
Do not continuously hold down the control knob as you may cause a build up of gas.
6. Once the pilot is lit hold down the control dial for at least 10 seconds until the main burner lights. Operate the fire
between the high and low flame settings as required.
7. If the pilot and main burner do not stay lit on releasing the control knob, turn the control knob to the ignition position
and repeat steps 3 to 4.
8. The is a pilot setting only.
To Turn Off Heater:
1. Turn the control knob to position.
2. Turn off the gas at the cylinder regulator valve.
NOTE
: The pilot light will remain alight until the cylinder regulator is turned off.
3. Disconnect the regulator from the cylinder when the heater is not in use.
Important: Read all the instruction Manual before using this appliance . This appliance must be installed in
accordance with such regulations as are in force. Installation to be carried out by a competent person.
Warning:
Do not use in leisure vehicles such as caravans and auto caravans.
In the event of a gas leak. ie. If you smell gas, turn off the cylinder valve. Disconnect the cylinder, take it
outdoors and contact a competent service technician.
Do not position the appliance close to walls, furniture, hangings, net curtains, bed linen and other inflammable materials
as this would result in the risk of fire. The guard (glass door) on this appliance is to prevent risk of fire or injury from burns
and no part of it should be permanently removed.
IT DOES NOT GIVE FULL PROTECTION FOR YOUNG CHILDREN OR
THE INFIRM
. For the full protection of young children or the infirm, we recommend a fireguard conforming
to BS 8423 be fitted.
Fig.1
Unscrew ignition button to fit
battery 1.5V type AA
