Page 28/37
WOOD CHIPPER | User manual
May 2021
Stationary blade
: Every machine is equipped with a stationary
blade that acts as a stop for the moving rotor blades.
WARNING
The machine is displayed without a cover or rotor cover for illustration purposes only. Do not use the machine
without a cover or guard or with an open cover or guard.
Sharpening blades
: The rotor and contra-rotating blades must
be sharp to ensure the wood chipper works as it should. We
recommend disassembling the rotor blades to sharpen them.
Always sharpen the blades at an angle of 45°; this guarantees
the best cuts with regards to the stationary blade. Make sure
the mounting bolts of the blades are tightened with the
specified torque when the blades are again installed on the
rotor.
The contra-rotating blade has 4 usable corners. If the corner on
the side of the rotor blade has rounded, you must disassemble
the blade and reposition it at the same position with another
corner on the side of the rotor blade. Tighten the mounting
bolts using the specified torque.
Clearance
: In view of achieving the best performance, a
clearance of 0.76 – 1.52 mm between the rotor and the
stationary blades is recommended. Set the clearance using the
mounting bolts for the stationary blade.
Stationary blade
Blades
