Title: RF Test Report for 3G MOBILE PHONE
Main Model: AC4E
Serial Model: ANDY AC4E, AC4EW
To: FCC Part 15.247: 2013, ANSI C63.4: 2009
Report No.: 13070549-FCC-R3
Issue Date: December 06, 2013
Page: 10 of 74
www.siemic.com.cn
5.2
§15.203 - ANTENNA REQUIREMENT
Applicable Standard
According to § 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by
the responsible party shall be used with the device. The use of a permanently attached antenna or of an antenna that uses
a unique coupling to the intentional radiator shall be considered sufficient to comply with the provisions of this section.
The manufacturer may design the unit so that a broken antenna can be replaced by the user, but the user of a standard
antenna jack or electrical connector is prohibited. The structure and application of the EUT were analyzed to determine
compliance with section §15.203 of the rules. §15.203 state that the subject device must meet the following criteria:
a.
Antenna must be permanently attached to the unit.
b.
Antenna must use a unique type of connector to attach to the EUT.
Unit must be professionally installed, and installer shall be responsible for verifying that the correct antenna is
employed with the unit.
And according to FCC 47 CFR section 15.247 (b), if the transmitting antennas of directional gain greater than 6dBi are
used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6 dBi.
Antenna Connector Construction
The EUT has 2 antennas: .a PIFA antenna for WIFI/Bluetooth/GPS, the gain is 0 dBi for WIFI/Bluetooth and -1 dBi
for GPS.
.a PIFA antenna for GSM and UMTS, the gain is -3 dBi for UMTS-FDD BandV/GSM850
and 0 dBi for UMTS-FDD Band II/PCS1900 .
which in accordance to section 15.203, please refer to the internal photos.
Result:
Compliance.