Dallas Delta Corporation Pty.Ltd.
Page 13
Button Call Number Assignment
PROGRAMMING (Phone Number menu)
The DDC_VoIP phone can be configured with up to 16 buttons, each may be assigned to dial
a different telephone number.
Click on the
Button Call Number Assignment
radio button and input the access code, then
click ‘Enter’.
Each Button, (if fitted) may be set to dial a different phone number. The Name field giving
to each input is for internal reference only and is not required.
The phone number may be an IP address/port number, ie 192.168.1.123:5060.
Sometimes, it may be required to dial this number without each DTMF tone played out of
the speaker, especially so, for long phone numbers like an IP address, to enable silence
dialling click
Yes
to the option
Dial numbers silently
in the
System section
, see page 9.
Special commands within the phone number
,
The DDC_VoIP unit can be configured to connect to a PSTN/PBX via a ATA. In this scenario the
unit calls the ATA and then, on answer, the DDC_VoIP phone then dials the PBX number.
To archive this, enter the first part of the number (the section that call the ATA) followed by a pipe
character ‘|’, and the PBX telephone number to call. (the PBX number may include a pause by
adding a comma ‘,’). Example, if the ATA number is 1234 and the PBX number is 9,91234567, then
you would enter 1234|9,91234567.
Note that the ATA number can be loaded in the
Dial Prefix
location, if all buttons calls are made
via the ATA, then set the Dial Prefix to ‘
1234|
’.
Note that the ATA number could well be an IP address.
