DDC POLYLASE MX, Руководство оператора

Страница: 55 / 61

- 14 -
Other System Features
HANDPIECE VEIN MODE
Figure 5-8. Vein Mode Screen.
The POLYLASE MX software allows both Nd:YAG and Alexandrite handpieces to
operate in
Vein Mode , i.e. with the optional insert objective. The optional VEIN
OBJECTIVE allows to operate the handpiece with 3 small spot sizes (2, 3 and 4 mm),
which allow to generate high fluences during spider and varicose vein treatment
(specifically, with Nd:YAG laser). This objective must be installed in the handpiece
output aperture instead of the Protective Window Holder prior to entering the
Vein Mode.
When this optional objective is installed, the user has to switch the laser into Vein Mode .
The handpiece mode selection button ( Vein or Hair ) is located on the footer toolbar on
the Edit screen (see Fig. 5-4 and 5-8). The laser is always in Hair mode by default after
system start-up, therefore, normally this button has the name Vein displayed on it. In
order to switch to Vein Mode , press and hold Vein button for at least 3 sec. The button
will change its name to Hair and the laser software will switch to Vein Mode (see Fig. 5-
8). The spot size selection options will change to 2, 3 and 4 mm and all displayed
Fluence values will be re-calculated reflecting small spot size selected. In order to switch
the laser back to
Hair mode, press and hold Hair button for at least 3 sec.
WARNING! POLYLASE MX does not have automatic recognition of the optional
VEIN OBJECTIVE. Please, remember to switch the laser into Vein Mode every
time you use the OBJECTIVE. Failure to do so will lead to incorrect Fluences
displayed and may result in patients’ skin burns and/or other injuries.