DD Audio ZVL, Руководство пользователя

Страница: 21 / 24

By linking 2 ZVL modules together you can expand the number of RCA outputs available
for distribution. There is no limit to the number of ZVL modules you can link.
1. If you want ZVL #2 to use the preamp settings from the ZVL #1 for matched control of
additional subwoofer amps set CH 5/6 on ZVL #1’s internal input jumper to PRE and set
all of ZVL #2’s input jumpers to
PASS
. This will copy the preamp setting from ZVL #1 to
all 5 outputs on ZVL #2. This will also allow all 5 output levels from ZVL #2 to be
controlled by ZVL #1’s remote control.
2. If you want ZVL #2 to use the full range signal from your source unit set CH 5/6 on ZVL
#1’s internal input jumper to
PASS
. Then configure ZVL #2 as needed.
3. Connect an RCA cable from ZVL #1’s CH 5/6 Output to ZVL #2’s INPUT.
The ZVL can be simultaneously used as a master volume controller and preamp for
multiple sub amps, and an active full range signal RCA distribution block.
LINKING MULTIPLE ZVL MODULES
DD AUDIO / ZVL / 20