DCS ADR24, Руководство по установке

Страница: 6 / 28

4
INSTALLATION
MAKE CUTOUT AND INSTALL SUPPORT STRUCTURE
1. Make a cut-out in your cabinet or island with the following dimensions (Fig. 3):
2. Place 2 X 4s to provide support for the Access Drawers structure in the locations indicated in the figure below
(Fig. 4).
3. Board lengths are provided in the table below (Fig. 5).
Fig. 5
A
90º
B
C
Vent*
Vent*
Vent*
Optimal support
locations
Fig. 4
C
B
A
8-3/4” 8-3/4”
CUTOUT DIMENSIONS
MODEL
A
(+0,-1/8)
B
(+1/8,-0)
C
ADR48 46” 20”
24-1/2” min.
(all models)
ADR36 34” 20”
ADR30 28” 20”
ADR24 22” 20”
Note:
The cutout of each corner should be 90º for the Access Drawers to fit properly.
SUPPORT BOARD DIMENSIONS
MODEL A B C
48” 44” 1-1/2” 3-1/2”* min.
36” 32” 1-1/2” 3-1/2”* min.
30” 26” 1-1/2” 3-1/2”* min.
24” 20” 1-1/2” 3-1/2”* min.
To ensure proper drawer operation, be sure your
support boards are flat & level.
* Island installation to use minimum of 3 vents
providing 10 sq. in. per vent (typical).
Optimal support locations.
*Dependent on application.
Fig. 6
4. When installing your support boards,
be sure they are level.
5. Check to be certain that the top
edges of your boards are level with
the bottom edge of the cut-out
(Fig. 6).
For proper support &
drawer operation, insure
that support boards are
level front to back & side
to side.
Support Board (typical)
Support Boards (typical)
Front View (typical) End View (typical)
Fig. 3