background image

FCC Notice

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment 

NOTE: This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a  

residential installation. This equipment generates, uses and can radiate radio  

frequency energy and, if not installed and used in accordance with the  instructions, 

may cause harmful interference to radio communications. However,  there is no 

guarantee that interference will not occur in a particular installation. If this equipment 

does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures: 

-- Reorient or relocate the receiving antenna. 

-- Increase the separation between the equipment and receiver.    

-- Connect the equipment into an outlet on a circuit different  from that to 

which the receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) this device may not cause  harmful interference, and (2) 

this device must accept any interference received, including interference that may 

cause undesired operation. 

When using this product, it should be installed and operated with a minimum distance 

of 7.9 in.(20 cm) for 2.4 GHz operations between the radiator and your body. This 

transmitter must not  be collocated or operate in conjunction with any other antenna 

or transmitter.

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled  environment. End users must follow the specific operating instructions 

for satisfying RF exposure  compliance. This transmitter must not be co-located or 

operating in conjunction with any other  antenna or transmitter.

Released: Rev 2.0 (1-16-2015)

Содержание EAP280-L












Отзывы: