Instruction manual VE1632TT STAND FAN 18 INCHES
dcg16.it
10
PRODUCT ASSEMBLY
ASSEMBLE OF BASE
• Firstly, loosen and remove the four screws from the bars. Then
cross bar A and bar B so that they interlock.
• Be sure to align the four holes in the bars with those on the flange
of the Outer Tube. Secure the flange to the bars with the four
screws.
• Loosen and remove the Height Adjustment Collar from the top
of the Inner Tube. Slide the Base Decorative Cap down over the
assembly.
• Replace the Height Adjustment Collar on top of the Inner Tube.
Pull the Inner Tube out from the Outer Tube to adjust the tube to
the desired height and tighten the collar.
• If necessary, slightly loosen the Set Screw by turning it anticlockwise.
Slide the Switch Box down over the Inner Tube and tighten the Set
Screw. Make sure the Set Screw is tightly secured.
