DCB Ether Series, Руководство пользователя

Страница: 21 / 64

Configuration
13
6. The configuration program should now start and after a few
seconds display a sign-on screen.
If nothing appears on your screen, press ESC.
Refer to the Terminal/Telnet Interface chapter for details
on using the configuration program.
Telnet Management
NOTE: To use telnet, there MUST be compatible IP addresses
in both the PC and the unit!
1. Install the unit into your LAN as described in Chapter 2.
Ensure that the unit is powered on.
2. Connect to it with the telnet program on your workstation.
A typical command is:
telnet IP_Address 8000
Where:
IP_Address
is the IP address of the unit.
8000 is the management port number. For example, if the
default IP address has not been changed, then you would
enter the command:
telnet 192.168.1.1 8000
If you can't connect
If the unit does not respond, check the following:
•
It is properly installed, LAN connections are OK, and it
is powered ON.
•
Check that your PC is using a compatible IP Address and
Network Mask .
In Windows, using Control Panel-Network to examine