DCB Ether Series, Руководство пользователя

Страница: 20 / 64

EtherSeries EMB-02 User’s Guide
12
Terminal Configuration
Terminal configuration requires the following:
•
PC with terminal emulation program, or a dumb terminal.
•
Serial cable to connect the PC to the unit. See the
Appendix for cable requirements. A Crossover (null
modem) cable is required when using a 9-pin PC port.
•
Serial port 1 must be configured as an RS-232 port. This is
the factory default configuration.
Procedure
1. Connect the unit to your PC or terminal.
2. Connect the unit to the power supply.
3. Press the configuration setup switch momentarily. It is
located to the side of the power connector and accessed
through a small hole. Use a small pen or paper clip to
access the switch.
4. Configure the terminal program with the following settings.
Setting Value
Flow control protocol None
Speed 9600
Data 8 bits
Parity None
Stop Bit 1
5. Connect your terminal program to the appropriate port (e.g.
COM 1).