DBL Technology EP-636 User Manual
dial mode.
14
15
16
17
18
TRANSFER
MUTE
FLASH
REDIAL
MONITOR
Press this key to transfer a call to another phone terminal.
Press this key to mute the voice signal transmitting to the other
part. LCD shows “Mute” status. Press this key again to resume
the voice signal transmission.
When endpoint type use SIP Phone, Press this key to answer a
waiting call or hold the current call and enter dial mode.
Press this key to redial the last outgoing call.
Press this key for hands free dial or call monitoring.
19
SPEAKER(LED)
It illuminates while the call is in “speakerphone” status.
20
HOLD (LED)
It illuminates when a call is in hold.
1.7 Rear View
2 Installing the IP Phone
2.1 Preparing the IP Phone
It is important to follow the installation procedures below in order to make sure the correction of
operation and to avoid damages to the IP Phone.
1) Connect the Coiled Phone Cord to the Handset and to the IP Phone Main Unit as shown in
the Front View.
2) Plug the AC Power Adaptor supplied to the Power Port of the IP Phone Main Body. Plug the
other end of the AC Power Adaptor to a wall outlet. Make sure that the wall outlet voltage
matches the specified input voltage on the Adaptor. Incorrect AC Voltage supply may damage
the Adaptor or cause the IP Phone not to function properly.
3) Connection to the LAN port allows the IP Phone to access the internet. You need to prepare
an Ethernet Cable for this connection.
Depending on your network environment, the IP Phone can be set to function as one of the
following two modes:
1) Non-Router Mode – Connect the LAN port to your broadband router or broadband
HUB/Switch.
2) Router Mode – Connect the LAN port to your broadband modem (ADSL/Cable), LAN
Hub/Switch or Virtual PC port.
For more detailed information, refer to the connection diagrams as shown below.
•
8