7
LOWERING AND RAISING A MANUAL ADJUSTABLE FRAME SYSTEM
NOTE:
This section only applies to Frame Systems that are manually adjusted. If your system is hydraulically
adjustable, move to the section titled Positioning and Stabilizing the Frame System. If your system is not
adjustable, disregard this section and move to the section titled Positioning and Stabilizing the Frame System.
IMPORTANT:
On each leg of the frame system there is an angle that allows a cross-over connection bar to be
installed. This bar allows the user to raise and lower the unit with a small forklift in a safe position.
Step 1:
Position the cross-over connection bar across two legs of the frame system that are on the same
end and secure with the provided fasteners.
Step 2:
Support the cross-over connection with a forklift rated lifting the weight of the frame system.
Step 3:
Using the wheel jacks, raise or lower the system until the pins are loose enough to remove.
Step 4:
Remove the pins holding the inner tube through the outer tube of the leg and slowly raise one end
of the frame with the forklift. Once the desired height is achieved, replace the pins through both
tubes.
Figure 6 - Lift Using the Cross-Over Connection Bar
Lift where cross-over
connection bars are located.
Figure 7 - Setting the Frame System to the Desired Height.
Install both leg bolts
to maintain height
