23
Cod. 420120298 REV. 1.0
VIO X205
INPUT, OUTPUT, RDNET AND CONTROL SECTION
4. “DSP Preset” - ROTARY
The presets that can be directly selected are the following:
Fullrange, HPF (85, 90, 95, 100, 110, 120).
Please note that these are immediate selections that can be set locally on the control panel. In remote control,
with AURORA NET (RDNET connection) it is possible to configure the details, even in a more in-depth manner. In
this case the local settings will be bypassed by the software.
1. INPUT AND OUTPUT LINK (“Balanced audio”)
Input and output compatible with balanced XLR cables.
In particular, "Input" is used to connect the audio signal
coming from the mixer or from another loudspeaker,
"Output Link" is used to link the signal to other
loudspeakers. Daisy-chain configuration.
2. “ATTENUATION”
It allows adjusting the input sensitivity, range [0 dB / -12 dB],
allowing also to mute the speaker [mute].
3. INPUT AND NETWORK CONNECTION LINK RDNet
Section compatible with network cables with etherCON/RJ45
connectors.
In particular, "Data in" must be connected to devices such
as RDNet Control 2 or Control 8; "Data Out" is used to
link the network to additional loudspeakers in daisy-chain
configuration.
5. STATUS LEDs
LEDs relating to speaker operation. See explanatory table in the following page.
6. RDNet CONTROL LEDs
LEDs relating to module network operation (RDNet).
In particular, if "Link" is on the RDNet network is active and has acknowledged the device, if "Active" is flashing
there is data traffic, if "Remote Preset Active" is on all local control on the amplifier panel are by-passed by the
RDNet remote control.
7. SERVICE DATA USB PORT
It is a USB B port to be used only for product firmware update. For further information refer to "FIRMWARE
UPDATE".