CBT36K Assembly Manual
Page
64
of 89
The next photo shows the display after this
information has been entered.
12.1.10.7. Step Five, Set Up the Mid-Bass EQ:
The next five steps set the EQ for the mid-bass
channel on output two. This is found on page 3
of 8 of channel two’s output menu.
Press [PAGE>] [EQ: ON]
[NR: 1] [TYPE: LP] [FREQ: 50Hz] [GAIN:
+15.0dB] [>12dB]
[NR: 2] [TYPE: BP] [FREQ: 620Hz] [GAIN:
+1.8dB] [Q 2.8]
[NR: 3] [TYPE: BP] [FREQ: 1.09kHz]
[GAIN: -3dB] [Q 5.6]
[NR: 4] [TYPE: BP] [FREQ: 1.78kHz]
[GAIN: -1.5dB] [Q 2.8]
The following photo shows the display after
these steps are completed.
12.1.10.8. Step Six, Set Up the Tweeter Channel:
These steps set up the tweeter channel
crossover filters on output three (and with linking
channel six). This is found on page 2 of 8 of
output three’s setup menu.
Press [OUTPUT 3] [<PAGE]
Set the high pass filter parameters to
[TYPE: L-R24] [FREQ: 1.00kHz].
Set the low pass filter parameters to
[TYPE: OFF].
The next photo shows the front-panel display
after these steps are completed.
12.1.10.9. Step Seven, Set Up Tweeter EQ:
The following six steps set up the tweeter EQ on
output three, which is found on page 3 of 8:
Press [PAGE>] [EQ: ON] and enter the
following parameters:
[NR:1] [TYPE: BP] [FREQ: 1.00kHz]
[GAIN: -4.5dB] [Q: 6.3]
[NR:2] [TYPE: HP] [FREQ: 1.00kHz]
[GAIN: +4.0dB] [>12dB]
[NR:3] [TYPE: BP] [FREQ: 1.14kHz]
[GAIN: -2.4dB] [Q: 10]
[NR:4] [TYPE: BP] [FREQ: 1.24kHz]
[GAIN: +1.5dB] [Q: 10]
[NR: 5] [TYPE: BP] [FREQ: 3.85kHz]
[GAIN: -5.0dB] [Q: 5]
[NR:6] [TYPE: HP] [FREQ: 7.01kHz]
[GAIN: -3.0dB] [>12dB]
The following photo shows the front-panel
display after these seven steps are completed.
12.1.10.10. Step Eight, Set Up Tweeter Time Delay:
The next two steps set the tweeter time delay on
output three. This is found on page 8 of 8.
Press [Page>] [Page>] [Page>] [Page>]
[Page>]
Set [DLY: ON] [SHORT: 60mm]
After entering these steps the front-panel display
appears as follows:
12.1.10.11. Step Nine: Set Tweeter Level:
The following two steps set the tweeter level on
output three. This is found on page 1 of 8.
Press [Page>]
Set OUT 3 GAIN: to [+1.5dB]
