CBT36K Assembly Manual
Page
20
of
89
5.2.2.
Bend Resistor Leads:
Bend the leads on one of the resistors as shown.
5.2.3.
Wrap the Bent Leads:
Wrap the bent leads three times around the
straight leads.
5.2.4.
Trim Longer Leads:
Trim the longer leads to 1/2 inch and trim the
twisted wire close to the long lead.
Save the longer cutoffs for later use. (20 will be
needed later!)
5.2.5.
Straight-Lead Parallel Resistor
Configurations:
Prepare eights sets of straight-lead parallel resistor
combinations following the previous photos (each
set has two resistors in parallel), as follows:
1) 5 Ohm and 5 Ohm (two pairs)
2) 3 Ohm and 3 Ohm (two pairs)
3) 2 Ohm and 2 Ohm (two pairs)
4) 1.5 Ohm and 1.5 Ohm (two pairs)
5.2.6.
Bent-Lead Parallel Resistor
Configurations This One is Different!
Configure two sets of parallel 1.5 Ohm resistors
with a 90 deg bend on the left side as shown in the
following photo. The part that bends downward
should be about 1/4 of an inch long.
1) 1.5 Ohm and 1.5 Ohm (two pairs)
5.3.
C
ONFIGURE AND
T
RIM THE
R
ESISTOR
L
EADS
:
Configure and trim the leads as shown for two
each of 1.0, 1.5 and 2.5 ohm resistors.
5.3.1.
Bend Leads:
Bend the right lead 90 degrees after it exits from
the resistor body.
5.3.2.
Second Bend:
Hold the lead with needle nose pliers and make a
second bend as shown.
