6
Connecting Speakers
The amplifier can power speakers with a minimum impedance of 4Ω, using speakers with
a lower impedance can cause damage to the amplifier. Use high quality two conductor
speaker wire and your choice of connector to connect your speakers to the binding posts
on the rear of the unit.
Connect the DTA-100ST’s left speaker terminals marked “L-” and “L+” to the corresponding
“-” and “+” terminals on your left speaker. Repeat the same process for the right channel.
NOTE:
Never connect the negative terminals together or to ground. The DTA-100ST is not
designed to operate in a bridged mode and attempting to do so may damage the amplifier.
Operation
Bluetooth Operation
When switching to the Bluetooth input, the indicator light will flash to indicate that the device
is ready to pair. If the last connected device is within range it will connect automatically.
Otherwise, look for the DTA-100ST in your device’s setup menu and initiate pairing.
The DTA-100ST will automatically disconnect after 15 minutes of silence and
enter standby.
AUTO ON Function
For ultimate control in any installation, the DTA-100ST has an auto sensing function that
can turn off the amplifier when not in use and turn it back on when audio is detected.
When the DTA-100ST is in standby the power indicator will illuminate red. To activate this
function, toggle the AUTO ON switch. Otherwise, leave the switch in the ON position for
normal operation.
When using the AUX input, the DTA-100ST will enter standby after fifteen minutes of
silence. The amplifier will turn back on when music is played again. The power light will
change to white and the AUX input light will light up again. The DTA-100ST will remain in
standby until audio is sensed on the line inputs, or the front panel controls are used.
While using the Bluetooth input the DTA-100ST will unpair from the connected device after
fifteen minutes of silence and enter standby. The power light will illuminate red and the
Bluetooth light will flash to indicate that pairing mode is active. The DTA-100ST will remain
in pairing mode until a Bluetooth device connects or the front panel controls are used.
Amplifier,Model NO.:DTA-100ST
100-240V~
50Hz/60Hz 100W
