87352
③
/
⑧
December 17, 2014
Package Contents
Part Name
––
Using the Smartphone Controller
––
1. Installing batteries
Remove the battery case lid on the side panel of the Smartphone Controller using a coin, insert the button batteries included in the
package into the battery case, and then replace the lid.
CAUTION
* Insert the button batteries in the correct orientation by paying attention to the polarity of the batteries.
* Attach the water-resistant O-ring carefully before you replace the lid. If the position of the O-ring is slightly off, water-resistant
performance will decline and water might enter the unit.
* The rotatable angle of the battery case lid is about 5 degrees. Do not use force to rotate it further.
Otherwise, the lid will be damaged.
* Supplied batteries have been used to check the operation at the
time of shipment from the factory.
Therefore, the life of the original batteries may be short.
Daytona Corp. recommends that you replace the batteries
before you start using the Smartphone Controller.
・
Remote controller x1
・
Spacer x2
・
Clamp x1
・
Clamp fixing screw x2
・
Rubber spacer
(Long) (Short) x2 each
Escape button
Cross joystick
Power button
Enter button
Clamp fixing
screw
LED
indicator
Home button
Clamp
Battery
case lid
O-ring
Button
battery
Spacer
Clamp
Clamp
fixing
screw
Spacer
Rubber spacer
* If the diameter of the handlebar is
φ
25.4mm or
φ
22.2mm, attach the
rubber spacers to the inner side of the
spacers.
Open
Close
＋
－
2. Installing the Smartphone Controller on your vehicle
・
Remove the clamp fixing screws to remove the clamp from the Smartphone Controller body, and then install the clamp and
Smartphone Controller body in a location on the handlebar or grip that will not interfere with your driving.
Use the supplied spacers or rubber spacers, depending on the thickness of the handlebar or grip. The inner diameter of the
Smartphone Controller is approximately
φ
38mm without any spacers. The diameter will become
φ
31mm if the spacers are attached.
If the diameter of the handlebar is
φ
25.4mm or
φ
22.2mm, attach the rubber spacers to the inner side of the spacers.
CAUTION
* Do not insert the clamp fixing screws on a slant, and do not tighten them too much. Otherwise, the screw holes on the Smartphone
Controller and the clamp fixing screws will be damaged. Tighten the screws carefully.
