5. Setting the brightness of daylight and night light:
Press the S2 and S3 buttons at the same time. The status LED will illuminate red. First, daylight is
activated; it can be dimmed using the S2 and S3 buttons. The connected light will blink once the
maximum value is reached. Press the S2 button (to dim) or the S3 button (to brighten) to adjust
the lighting. The status LED will flash red quickly to confirm this action. Press S2 and S3 at the
same time to switch between daylight and night light. The night light is also adjusted by pressing
S2 and S3. It can be dimmed to a value of 0% (off). The device will return to normal operations if
the S1 button is pressed or if no button is pressed for about 5 – 6 seconds. The status LED will
illuminate green again. The adjusted values are saved automatically.
Note: If the brightness for the day and/or night light changes during the sunrise or sunset, the
sunrise/sunset is terminated as soon as the change is finished and the light is displayed according
to the time. For example: The selected transition time for sunrise and sunset is 30 minutes. The
brightness is changed during the transition from daylight to night light. Thus, after this changed
value is applied, the controller will "jump" directly to the night light phase.
6. Setting the transition period (duration of sunrise and sunset):
The transition period (the duration of the change from daylight to night light stored and vice versa)
can be adjusted at any time during normal operations. To set this, press the S2 button briefly, five
times in succession. The status LED will start to blink. The blinking pattern indicates the transition
stage, as follows:
One time blinking red
– pause: Transition stage 1: 0 min (
only switches, without a transitional period
)
Two times blinking red – pause: Transition stage 2: 1 min
Three times blinking red – pause: Transition stage 3: 5 min
Four times blinking red – pause: Transition stage 4: 15 min
Five times blinking red – pause: Transition stage 5: 30 min
Six times blinking red
– pause: Transition stage 6: 60 min
The stage can be selected by pressing the button S2 (-) or S3 (+). The corresponding blink code
will be displayed immediately after the change is made. You can also wait and observe the
change. After you have selected the desired time for the transition phase, press the S1 button to
save your selection. The normal operation mode will then resume.
7. Setting the start and end of the pause:
As a special function, a pause time can be set. The light will be switched off during the specified
pause start and pause end.
To set the start of the pause, press the S2 button and hold it down until the status LED starts to
blink red. Then press the S1 button to specify the number of hours (e.g. pressing zero times =
00:00 / press twice = 02:00). Then release the buttons. The red status LED will then return to
green after a short time; this indicates that normal operations have resumed.
