Days EQUALIZER SYSTEMS EQ Smart-Level, Инструкция по установке/эксплуатации/гарантии

Страница: 19 / 28

19
Operation
Auto Level Operation
Push and release the power button to engage power. The LED light next to the power button should be
lit RED when power is on. You will need to have the ignition key in the off position to extend the jacks
(most applications). If you attempt to manually extend jacks or all jacks with the Auto Level button,
you will hear a deny tone from the keypad if the ignition key is in the on (engine run) position (most
applications). Also depending on if the park brake disable is connected and the park brake is released
you may not be able to extend jacks.
Press the Auto Level button and release. The system will send out a continuous series of beeps and
the “Operating” LED will be on to let you know Auto Level is operation and will automatically level the
coach. Do not move around or exit the coach during this operation, doing so will fault out the operation
or result in an incomplete leveling/stabilization operation. When completed, the Keypad will signal
the successful completion with a dual-stage tone. The Keypad may be left on once level has been
achieved. The Keypad will enter “sleep mode” after five minutes of inactivity.
Note: Auto Level will be denied if the jack indicator lights are on. To clear this press all, retract then
perform Auto Level.
Setting the Null: Null is the term used to indicate the levelness of the coach. A Null setting should have
been performed by the installer. If the coach is not level following an attempt to Auto Level, you will
need to level the coach and reset the null. To set the null, push and release the Power button on the
Keypad to engage power. The LED light next to the Power button should be lit RED when the power is
on. Level the coach by deploying jacks manually, or by simply parking the coach on a level site. You do
not need to have the jacks deployed to set the null. Use a bubble level on a flat surface in the center
of the coach as a reference. Once the coach is level, turn the power off at the panel. Depress and hold
the Auto Level button and press and release the Power button and listen for a series of beeps. After the
Keypad has beeped 5 to 6 times (the Keypad will continue to beep as long as the Auto Level button is
held) release the Auto Level button you should get a confirmation beep. The new null has been set and
the panel will store/remember this setting. Press and release the All Retract button to retract the jacks
to the stowed position.
Use the All Retract button to retract the jacks prior to travel. This system does provide the ability to
retract the jacks using the UP buttons for each pair of jacks. However, these buttons are not intended
to be used for retracting the jacks to their stowed position prior to travel. The Up arrows are to be used
only for retracting the jacks to help level the coach. The All Retract button must be pressed to ensure
the system is ready/safe for travel. All jacks should automatically retract and return to stowed position
when the ALL RETRACT button is pressed and released. The pump will run in retract for approximately
5 seconds after the last jack has been fully retracted- or until a time limit of 90 seconds has been
reached.
*It is always the responsibility of the coach operator to visually
confirm that the jacks are fully retracted and safe for travel*