14
13
Assembly Steps
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, please check the gap between
the screw thread and the collapsible (refer to below picture), if the gap is
too big, please add two or three washers inside the wheel, But after
tightening the nut outside the wheel, please turn the wheel by your finger to
check if the wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel and the
wheel can’t run smoothly, the motor will be broken easily! Then you need to
decrease one or two washers to make sure the wheel can run smoothly!
GAP
Tab
Seat
M5x12 machine
screw
Light bar
support
Light bar
Light bar
assembly
Ø4x12
flat head
screw
●
Insert the tabs at the back of the seat
into the slots in the vehicle body.
●
Tighten two M5x20 machine screws
with a screwdriver.
●
Fit the light bar support to light bar, insert four
Ø4x12
flat head screws and tighten with a
screwdriver.
●
Repeat for the other light bar support.
●
Insert the tabs on the light bar support into the slots in the vehicle body, push until you hear it
click into place.
