DAYLIFF Poolchlo30, Инструкция по установке и эксплуатации

Страница: 7 / 24

4 4
DO NOT add chemicals or salt directly to the skimmer.
This may damage the cell.
Use only evaporated, granulated, non-iodized salt (Sodium Chloride). The purer
the salt (at least 99%), the longer the life and performance of the Electrolytic Cell.
WARNING
If the Electrolytic Cell has already been installed, it should not be turned on
before adding salt. For pools, it is best to empty the required salt into the shallow
end of the pool and run the filter and pump simultaneously in order to circulate
the water and dissolve the salt (the chlorinator is to remain off during this time
period).
Do not throw the salt bag into the water as chemicals
and inks on the bag can interfere with water balance.
CAUTION
Salt may take 24 - 48 hours to dissolve. Finer granules of salt will dissolve faster
than compressed pellets.
Ensure good salt quality 99% pure NaCl may be used. Avoid using salt with anti-
caking agents (Sodium Ferrocyanide, also known as YPS or Yellow Prussiate of
Soda) that could cause discoloration of fittings and surface finishes in pool. Do
not use Calcium Chloride as a source of salt. Do not use Rock Salt; insoluble
impurities mixed with the rock salt can shorten the life of the unit.
Salt Levels:
The system can work within a broad salinity range, from a minimum of 3000 ppm
(parts per million), up to 4000 ppm. However, the ideal level for operation is
3
about 3400 ppm. To achieve this level of salinity, add 3.4 kgs of salt/m of water
or 3.4kgs per 1000 litres of water.
Free Chlorine
Swimming Pools
Salinity
pH
Cyanuric Acid (Stabilizer)
Total Alkalinity
Calcium Hardness
Saturation Index
1.0 to 3.0 ppm
3000 to 4000pm
7.2 to 7.8
60 to 80 ppm
80 to 120 ppm
200 to 400 ppm
-0.2 to 0.2
Spas
3.0 to 5.0 ppm
3000 to 4000pm
7.2 to 7.8
60 to 80 ppm
80 to 120 ppm
150 to 450 ppm
-0.2 to 0.2