DAYLIFF DPL 550, Инструкция по установке и эксплуатации

Страница: 9 / 16

Ÿ
For installation above water level, use a shorter
suction pipe to reduce priming time.
Ÿ
Install the pump horizontally as close as possible
to the edge of the pool.
Ÿ
Provide adequate support for the suction and
delivery pipes so that they do not weigh down on
the pump. Do not make the couplings between
the pipes too tight.
Ÿ
Do not immerse the motor in water.
Ÿ
To avoid problems in suction, make a positive
slope of the suction pipe towards the pump.
Ÿ
Ensure proper tools and equipment are used for
all connections.
Ÿ
Before starting the motor the first time or when
system is drained, the pump should be primed
by opening the lid of the pump leaf basket and
adding water to cover the basket.
Ÿ
We e k l y m a i n t e n a n c e o f t h e p u m p i s
recommended. It is important that pump and
skimmer baskets are cleaned and any debris
removed.
Ÿ
Installations should be done on a firm flat base not
exposed to flooding.
Ÿ
Do not over tighten fittings into the inlet and outlet
of the pump.
Ÿ
For installation below water level, fill the pump
slowly and completely open the valves in the
suction pipe and on the delivery side expel the air.
Installation, electrical connection and commissioning must be
carried out by skilled personnel in compliance with local safety
regulations. Failure to comply with these instructions causes
risk to personal safety, damages the equipment and validates
warranty.
3. INSTALLATION