Dawson MULCH MATE DS1000, Руководство по установке

Страница: 10 / 27

At least four bolts per latch plate are recommended. Mark the holes (8 total).
These plates MUST be square and level to the body of the truck, parallel to each other,
and they must be pressed upwards against the latch tubes on the Mulch Mate. With the
hole locations marked, remove the plates and drill the holes up to ½” into the truck. Bolt
the plates to the truck so that the head of the bolts are on the outside of the truck bed.
These latch plates use the same ½" x 4.5” carriage bolts and flange locking nuts.
Tighten to the same 60 ft lbs torque spec as before. Once these plates are on the truck
you can start assembling the pivoting latches (fig 9).
10
3/24/2022 Rev 07