When newly powered WS433-CL, the configuration of 40 nodes will be read from flash, sync status = 99
When pinning or powering on the node ==> the node sends the registration packet to WS433-CL which contains the
configuration of the node ==> Configuration from the node will be overwritten on the configuration area on WS433-CL
==> Save flash ==> Sync completed, sync status = 0
When user wants to change configuration on node ==> Use modbus RTU command 16 write to configuration area on
WS433-CL ==> sync status = 1: WS433-CL wait for node to send data ==> When node send data up then WS433-CL
will send the configuration to node ==> node sends back authentication ACK containing this new configuration part
==> sync status = 0: sync configuration OK ==> user should read this configuration again to check if it's correct or
not
First, you need to prepare
Step 1: Connect Antenna, RS485 - configuration cable and power supply co-ordinator
6. Configuration
6.1 Reset sensor and iConnector sensor node