DAVIS Vantage Pro2 Plus, Руководство пользователя

Страница: 23 / 60

Setup Mode
19
Screen 14: Serial Baud Rate
The Baud Rate screen displays only if the console detects that a WeatherLink data
logger installed on the console.
The console uses a serial or USB port to communicate with a computer. If you are
connecting the console directly to your computer via USB or Ethernet, leave the
setting at 19200, the highest rate for the port. If you’re using a modem, use the
highest setting your modem can handle. The console must be equipped with a
WeatherLink data logger to communicate with a computer or modem.
Screen 14: Baud Rate
Note: The baud rate setting on your console must match the baud rate of the software you
are using. If you are using WeatherLink for Vantage Pro2, refer to WeatherLink help
for instructions on setting the serial port baud rate on your computer.
1. Press the + and - keys to select the baud rate.
Your Vantage Pro2 console supports baud rates of 1200, 2400, 4800, 9600,
14400, and 19200.
2. You have completed the console setup. To exit Setup Mode, press and hold
DONE until the current weather screen appears.
Clear All Command
After you have completed the above setup procedures and have exited the Setup
Mode, please use the Clear All command before putting your weather station into
service.
The Clear All command clears all stored high and low weather data including
monthly and yearly highs and lows and clears the alarm settings. The command is
recommended to properly clear the console of any erroneous data before first
putting the station into use.
1. Make sure wind speed is showing in the wind compass. If wind direction is
showing, press WIND on the console until wind speed appears.
2. Press 2ND, then press and hold CLEAR for at least six seconds.
3. Release CLEAR when you see “CLEARING NOW” displayed at the bottom
of the console’s screen.